•  
  •  
 

Keywords

Exhaust temperature, Thermoelectric cell, Electrical power generation, BSFC, Emissions

Document Type

Research Paper

Abstract

The thermoelectric cell generators (TECG) convert thermal power into electrical power generated. The main factor in its operation is the temperature difference (TD) between its surfaces. An experimental investigation was conducted into the waste heat recovery performance of the TECG system. Forty thermoelectric cells (TECs) are supported on the (4 5) upper and (4 5) lower and upper arrangement of the engine exhaust manifold. The electrical power generated (EPG), exhaust gas flow rate, exhaust temperature, brake-specific fuel consumption (BSFC), and exhaust emissions were experimentally investigated under different engine speeds and 50 N.m and 100 N.m engine load conditions. Comparative results of the BSFC and emissions have ben measured with and without the TECG system. Experimental results observed that the maximum power values generated are approximately 218.5 W by TECG. An engine BSFC has been reduced by (2.56%:2.89%) under the TECG. The results show the improvement of CO is approximately 1.92% and 5.12% with the TECG system at loads 50 N.m and 100 N.m, respectively, and CO2 emission improvement by 4.32% and 4.52% with the TECG system throughout the speed range and two engine loads. The proposed TECG system, supported by a gasoline engine, is effective under high engine speed and load.

References

A. Z. Sahin, B. S. Yilbas, S. Z. Shuja, O. Momin, Investigation into topping cycle: Thermal efficiency with and without the presence of thermoelectric generator, Energy, 36 (2011) 4048 - 4054. https://doi.org/10.1016/j.energy.2011.04.044 B.Orr, B.Singh, L. Tan, A. Akbarzadeh, Electricity generation from an exhaust heat recovery system utilizing thermoelectric cells and heat pipes, Appl. Therm. Eng., 73 (2014) 588-597. https://doi.org/10.1016/j.applthermaleng.2014.07.056 C.Yu, K.T. Chau, Thermoelectric automotive waste heat energy recovery using maximum power point tracking, Energy Convers. Manag., 50 (2009) 1506–1512. https://doi.org/10.1016/j.enconman.2009.02.015 D. T. Crane, G. S. Jackson, Optimization of cross flow heat exchangers for thermoelectric waste heat recovery, Energy Conv. Manag., 45 (2003)1565-1582. https://doi.org/10.1016/j.enconman.2003.09.003 I. Temizer, C. Ilkılıç, The performance and analysis of the thermoelectric generator system used in diesel engines, Renew. Sustain. Energy, Rev., 63 (2016) 141–51. https://doi.org/10.1016/j.rser.2016.04.068 J. Merkisz, P. Fuc, P. Lijewski, A . Ziolkowski, M .Galant, M. Siedlecki, Analysis of an increase in the efficiency of a spark ignition engine through the application of an automotive thermoelectric generator, J. Electron. Mater., 45 (2016) 4028 - 4037. https://doi.org/10.1007/s11664-016-4543-0 X. Liu, Y.D. Deng, Z. Li, C.Q. Su, Performance analysis of a waste heat recovery thermoelectric generation system for automotive application, Energy Convers. Manage., 90 (2015) 121-127. https://doi.org/10.1016/j.enconman.2014.11.015 G. Liang, J . Zhou, X . Huang, Analytical model of parallel thermoelectric generator, Appl. Energy, 88 (2011) 5193-5199. https://doi.org/10.1016/j.apenergy.2011.07.041 J. Ringler, M. Seifert, V. Guyotot, W. Hübner, Rankine cycle for waste heat recovery of IC Engines, SAE Int. J. Engines., 2 (2009) 67-76. https://www.jstor.org/stable/26308377 X. Gou, S. Yang, H. Xiao, Q. Ou, A dynamic model for thermoelectric generator applied in waste heat recovery, Energy 52 (2013) 201- 209. https://doi.org/10.1016/j.energy.2013.01.040 S. Yu, Q. Du, H. Diao, G. Shu, G. Jiao, Start-up modes of thermoelectric generator based on vehicle exhaust waste heat recovery, Appl. Energy, 138 (2015) 276–290. https://doi.org/10.1016/j.apenergy.2014.10.062 JH. Meng, XX. Zhang , XD. Wang, Dynamic response characteristics of thermoelectric generator predicted by a three-dimensional heat-electricity coupled model, J. Power Sources, 245 (2014) 262-269. https://doi.org/10.1016/j.jpowsour.2013.06.127 X. Gou, H. Xiao, S.Yang, Modeling, experimental study and optimization on low temperature waste heat thermoelectric generator system, Appl. Energy, 87 (2010) 3131-3136. https://doi.org/10.1016/j.apenergy.2010.02.013 X. Liang, X. Sun, H. Tian, G. Shu, Y. Wang, X. Wang, Comparison and parameter optimization of a two-stage thermoelectric generator using high temperature exhaust of internal combustion engine, Appl. Energy, 130 (2014) 190-199. https://doi.org/10.1016/j.apenergy.2014.05.048 E. S. Mohamed, Development and performance analysis of a TEG system using exhaust recovery for a light diesel vehicle with assessment of fuel economy and emissions, Appl. Thermal Eng., 147 (2019) 661-674. https://doi.org/10.1016/j.applthermaleng.2018.10.100 Y. Y. Hsiao, W. C.Chang, S. L.Chen, A mathematic model of thermoelectric module with applications on waste heat recovery from automobile engine, Energy, 35 (2010) 1447- 1454. https://doi.org/10.1016/j.energy.2009.11.030 XD. Wang, YX. Huang, CH. Cheng, DW. Lin, CH. Kang , A three-dimensional numerical modeling of thermoelectric device with consideration of coupling of temperature field and electric potential field, Energy, 47 (2012) 488- 497. https://doi.org/10.1016/j.energy.2012.09.019 A. Rezania, L. A. Rosendahl, Thermal effect of a thermoelectric generator on parallel microchannel heat sink, Energy, 37 (2012) 220-227. https://doi.org/10.1016/j.energy.2011.11.043 Y. K. Sofi, R. H. Hendaryati, A. Rahmandhika, R. Hidayatulloh, M. F. Budiman, G.W. As'adi, R. Zaroby, W. S. Nugroho, Small-Scale thermoelectric incinerator prototype for sustainable waste management and power generation, Eng. Technol. J., 42 (2024) 986 -1000. https://www.iasj.net/iasj/article/320011 K. Hanamura,T. Kumano,Y. Iida, Electric power generation by super-adiabatic combustion in thermoelectric porous element, Energy, 30 (2005) 347-357. https://doi.org/10.1016/j.energy.2004.05.010 J. Martins, L. Goncalves, J. Antunes, F. Brito,Thermoelectric exhaust energy recovery with temperature control through heat pipes, SAE Int. J. Engines, 2011(2011) 1-19. http://dx.doi.org/10.4271/2011-01-0315 A. Patyk, Thermoelectric generators for efficiency improvement of power generation by motor generators environmental and economic perspectives, Appli. Energy, 102 (2013) 1448-1457. https://doi.org/10.1016/j.apenergy.2012.09.007 M. Lossec, B. Multon, H. B. Ahmed, Sizing optimization of a thermoelectric generator set with heat sink for harvesting human body heat, Energy, Convers. Manage., 68 (2013) 260 - 265. https://doi.org/10.1016/j.enconman.2013.01.021 D. Astrain, J.G. Vian, A. Martinez, A. Rodriguez, Study of the influence of heat exchangers’ thermal resistances on a thermoelectric generation system, Energy, 35 (2010) 602- 610. https://doi.org/10.1016/j.energy.2009.10.031 F. Meng, L. Chen, F. Sun , Effects of temperature dependence of thermoelectric properties on the power and efficiency of a multielement thermoelectric generator, Int. J. Energy, Environ, 3 (2012) 137-150. E. F. Thacher, B. T. Helenbrook, M. A. Karri,C. J. Richter, TestingTesting of an automobile exhaust thermoelectric generator in a light truck, Proc. Inst. Mech. Eng. D. J. Auto. Eng., 22 (2007) 95-107. https://doi.org/10.1243/09544070JAUTO51 CT. Hsu, GY. Huang, HS .Chu, B. Yu , DJ. Yao, Experiments and simulations on low temperature waste heat harvesting system by thermoelectric power generators,Appl.Energy,88(2011)1291-1297. https://doi.org/10.1016/j.apenergy.2010.10.005 A. Al-Janabi , O. Alsalmi, E. Alsubhi, A. Alhadhrami, Thermoelectric Generators as a Heat Recovery System for Exhaust Gases of Vehicles Driving at Low Speeds, Eng. Technol. J., 41 (2023) 185-195. https://doi.org/10.30684/etj.2022.134206.1253 N. F. Numan, M. M. Mahdi, M. K. Ahmed, A Comparative Experimental Study Analysis of Solar Based Thermoelectric Refrigerator Using Different Hot Side Heat Sink, Eng. Technol. J., 40 (2022) 90-98. https://doi.org/10.30684/etj.v40i1.2058 C. Suter, Z. R. Jovanovic, A. Steinfeld, A 1 kW thermoelectric stack for geothermal power generation – modeling and geometrical optimization, Appl. Energy, 99 (2012)3 79-385. https://doi.org/10.1016/j.apenergy.2012.05.033 E. S. Mohamed, Experimental study on the effect of active engine thermal management on a bi-fuel engine performance, combustion and exhaust emissions, Appl. Thermal, Eng., 106 (2016) 1352-1365. https://doi.org/10.1016/j.applthermaleng.2016.06.123 E. S. Abdelghany, E. S. Mohamed , H. H. Sarhan, Exhaust heat recovery performance analysis of a Bi-fuel engine utilizing a thermoelectric generation kit and fuel economy evaluation, Case Studies , Thermal, Eng., 49 (2023) 103288. https://doi.org/10.1016/j.csite.2023.103288 Y. D. Deng, T. Hu, C.Q. Su , X. H. Yuan, Fuel Economy Improvement by Utilizing Thermoelectric Generator in Heavy-Duty Vehicle, J. Electron. Mater.,46 (2017) 3227-3234 . https://doi.org/10.1007/s11664-016-4996-1 M. A. Mansour , N. Beithou , A. Othman, A. Qandil , M. B. Khalid , G. Borowski , S. Alsaqoor, A. Alahmer , H. Jouhara, Effect of liquid saturated porous medium on heat transfer from thermoelectric generator, Int. J. Thermofluids., 17 (2023) 100264. https://doi.org/10.1016/j.ijft.2022.100264 P. Ni , R. Hua , H. Jiang , X. Wang , X. Zhang , X. Li , R.Hua, Thermal flow and thermoelectricity characteristics in a sandwich flat plate thermoelectric power generation device under diesel engine exhaust conditions, Energy, 308 (2024) 132815. https://doi.org/10.1016/j.energy.2024.132815 Seebeck, T. J. Magnetische Polarisation der Metalle und Erze Durch Temperatur-Differenz; in Ostwald's Klassiker der Exakten Wissenshaften Nr, Seebeck Biography 1. Seebeck Biography 2, Engelmann‏, 1895. M. V. Vedernikov, E. K. Iordanishvili, A. F. Ioffe and origin of modern semiconductor thermoelectric energy conversion, 7th Int. Conf. Thermoelec. Proc., 1 ,1998, 37- 42. https://doi.org/10.1109/ICT.1998.740313 P. Alexandre, S. Susanna , S. Lírio , History of Development of Thermoelectric Materials for Electric Power Generation and Criteria of their Quality, Mat. Res., 17 (2014) 1260-1267. https://doi.org/10.1590/1516-1439.272214

Highlights

The impact of a thermoelectric generator (TEG) arrangement on engine manifold performance was analyzed Electrical power generation with forty TEGs was detailed, highlighting system efficiency and energy output Comparisons of BSFC were made for engine operation with and without active TEGs for performance assessment Results showed lower emissions in engines equipped with active TEGs, suggesting environmental benefits

DOI

10.30684/etj.2024.153438.1815

First Page

42

Last Page

57

Download

Share

COinS