•  
  •  
 

Keywords

Waste paper ashes, flowability, chemical composition, pozzolan

Document Type

Research Paper

Abstract

This research was designed to assess the yield and quality of ash prepared from different types of waste papers. Waste newspapers, writing papers, and cartons were selected for combustion to obtain the ashes and coded as WNPA, WWPA, and WCPA, respectively. The waste papers were incinerated simultaneously in separate but identical incinerators at 850 ℃. An experiment on the yield of the ashes was performed on two days before the ashes obtained were mixed based on the type of waste papers from which they were derived. The results showed that irrespective of the day and time, the WCPA was the most yielded (14.1%), followed by the WWPA (12.3%), and then the WNPA (11.9%). Also, it was found that all the ashes possessed flow properties acceptable for engineering applications. However, the WCPA would ensure the best performance if applied, especially as a partial replacement material for cement. While the WWPA was found to be richer than the WNPA, the WCPA was the richest in terms of the proportions of key oxides for strength development. In general, the percentages of various chemical components of each ash complied with the standard specifications for cement except in the case of losses on ignition of the WNPA and WWPA, which were about 0.53% and 0.02%, respectively, beyond the maximum stipulated value.

References

W. Robert, S.A. Ekong, S.S. Akpan, S.E. Etuk, N.J. Inyang, O.E. Agbasi‏, Paper – Sawdust Composites: Fabrication and Comparison in terms of Heat Transfer and Strength Properties, Structure and Environment, 15 (2023) 38 – 48. https://doi.org/10.30540/sae-2023-005 Umoren, U. Okorie, A. Casmir, E. Umoren, Recycling of Waste Cartons and Musanga Cecropioides Heartwood into Composite Panels for Structural Application, Sci. Eng. Technol., 3 (2023) 75 – 83. https://doi.org/10.54327/set2023/v3.i2.89 Robert, S. Etuk, J. Emah, O. Agbasi, U. Iboh, Thermophysical and Mechanical Properties of Clay-Based Composites developed with Hydrothermally Calcined Waste Paper Ash Nanomaterial for Building Purposes, Int. J. Thermophys., 43 (2022) 1 – 20. https://doi.org/10.1007/s10765-022-02995-1 Haile, G. Gelebo, T. Tesfaye, W. Mengie, M. Mebrate, A. Abuhav, D. Limeneh, Pulp and paper mill wastes: utilizations and prospects for high value-added biomaterials, Bioresour. Bioprocess., 8 (2021)1-21. https://doi.org/10.1186/s40643-021-00385-3 O’mara, How much paper is used in one day? Record Nations, Last updated: February 10, 2016. www.recordnations.com Chepkemoi, The top pulp and paper producing countries in the world, World Facts, Last updated: September 25, 2017.www.worldatlas.com Adeniran, A. Nubi, A. Adelopo, Solid waste generation and characterisation in the University of Lagos for a sustainable waste management, Waste Manag., 67 (2017) 3 – 10. https://doi.org/10.1016/j.wasman.2017.05.002 Oladele, M. Okoro, Development of rattan (Calamus longipinna) particulate reinforced paper pulp-based composite for structural application using waste papers, Leonardo J. Sci., 14 (2015) 75 – 87. Robert, S. Etuk, O. Agbasi, Assessment of Thermal and Mechanical properties of composite board produced from coconut (cocos nucifera) husks, waste newspapers and cassava starch, Int. J.Thermophy., 40 (2019) 1 - 12. https://doi.org/10.1007/s10765-019-2547-8 Okeyinka, O. Idowu, Assessment of the Suitability of Paper Waste as an Engineering Material, Eng. Technol. Appl. Sci. Res., 4 (2014) 724 –727 .http://dx.doi.org/10.48084/etasr.485 Bochare, M. Dagliya, B. Sharma, F. Shaikh, Experimental Investigation on Waste Paper-pulp Infused Cement Mortar, IOP Conf. Series: Earth and Environmental Science, 1130 ,2023, 012006. https://doi.org/10.1088/1755-1315/1130/1/012006 Okorie, U. Robert, U. Iboh, G. Umoren, Assessment of the suitability of tiger nut fiber for structural applications, J. Renew. Energy Mech., 3 (2020) 32 – 38. http://dx.doi.org/10.25299/rem.2020.vol3(01).4417 Robert, S. Etuk, O. Agbasi, S. Ekong, E. Nathaniel, A. Anonaba, L. Nnana, Valorization of Waste carton paper, Melon seed husks and Groundnut shells to thermal insulation panels for structural applications, Polytechnica, 4(2021) 97 – 106. https://doi.org/10.1007/s41050-021-00034-w Robert, S. Etuk, O. Agbasi, S. Ekong, Z. Abdulrazzaq, A. Anonaba, Investigation of Thermal and Strength Properties of Composite Panels fabricated with Plaster of Paris for Insulation in Buildings, Int. J.Thermophys., 42 (2021) 25. https://doi.org/10.1007/s10765-020-02780-y Mitikie, D. Waldtsadik, Partial replacement of cement by Waste Paper Pulp Ash and its effect on Concrete Properties, Adv. Civil Eng., 2022(2022) 8880196. https://doi.org/10.1155/2022/8880196 Singh , S. Chandel, An examination and investigation compressive strength the use of waste paper sludge ash and rice husk ash as cement substitutes in concrete, Int. j. innov. res. eng.manag., 10 (2023) 60 – 66.https://doi.org/10.55524/ijirem.2023.10.3.11 Subanndi, F. Agustina, V. Vebrian, R. Azzahra, Waste Paper Ash as Additives for High Strength Concrete Mix 45 MPa,  Annales de Chimie Scie. des Matéri., 44 (2020) 91 – 96. https://doi.org/10.18280/acsm.440203 Meko, J. Ighalo, Utilization of waste paper ash as supplementary cementitious material in C-25 concrete: Evaluation of fresh and hardened properties, Cogent Eng., 8 (2021) 1938366. https://doi.org/10.1080/23311916.2021.1938366 Ekong, D. Oyegoke, A. Edema, U. Robert, Density and Water Absorption Coefficient of Sandcrete Blocks produced with Waste Paper Ash as Partial Replacement of Cement, Adv. Mater. Sci., 22 (2022) 85 – 97.https://doi.org/10.2478/adms-2022-0021 Putra, H. Herman, H. Medriosa, F. Nugroho, Effectiveness of waste paper ash for stabilization on clay soil, Rev. ing. constr., 37 (2022) 253 – 259. https://dx.doi.org/10.7764/ric.00030.21 Owaid, H. Al-Baghdadi,H. Owaid , H . Al-Baghddi, Use of WPA or Wood ash as substitution to fly ash in production of geopolymer concrete,Sci. Rev. Eng. Environ. Sci., 30 (2021) 464 – 476. https://doi.org/ 10.22630/PNIKS.2021.30.3.39 Reddy, C. Ramachandra, S. Hiregoudar, U. Nidoni, J. Ram, M. Kammar, Influence of processing conditions on functional and reconstitution properties of milk powder made from Osmanabadi goat milk by spray drying, Small Rumin. Res., 119 (2014) 130 – 137. http://dx.doi.org/10.1016/j.smallrumres.2014.01.013 Bediako, E. Amankwah, Analysis of chemical composition of cement in Ghana:A key to understand the Behavior of cement, Adv. Mater. Sci. Eng., (2015) 349401. https://doi.org/10.1155/2015/349401 Inegbenebor, A. Inegbenebor, R. Mordi, N. Kalada, A. Falomo, P. Sanyaolu, Determination of the Chemical Compositions of clay deposits from some part of South West Nigeria forindustrial applications, Int. J. Appl. Sci. Bio., 4 (2016) 21 – 26. https://doi.org/10.3126/ijasbt.v4i1.14214 Etiegni, A. Campbell, Physical and chemical characteristics of wood ash, Bio.Technol., 37 (1991) 173 – 179. https://doi.org/10.1016/0960-8524(91)90207-z Siddique, R. Wood ash waste materials and by-products in concrete, Berlin, Heidelberg: Springer, pp. 303 – 321. Berlin Heildelberg. https://doi.org/10.1007/978-3-540-74294-4_9 Lebrun, F. Krier, J. Mantanus, H. Grohganz, M. Yang, E. Rozet, B. Boulanger, B. Evrard, J. Rantanen, P. Hubert, Design space approach in the optimization of the spray-drying process, European. J.Pharmaceutics Bio., 80 (2012) 226 – 234 .https://doi.org/10.1016/j.ejpb.2011.09.014 USP, Powder Flow. In: The United States Pharmacopeia 30-National Formulary 25 Convention, Rockville, 2007. Guiling, C. Xiaoping, L. Cai, X. Pan, Z. Changsui, Experimental investigation on the flowability properties of cohesive carbonaceous powders, J. Particulate Sci. Technol., 35 (2016) 322 – 329. https://doi.org/10.1080/02726351.2016.1154910 Robert, S. Etuk, S. Ekong, O. Agbasi, N. Ekpenyong, S. Akpan, E. Umana, Electrical characteristics of dry cement – based composites modified with coconut husk ash nanomaterial, Adv. Mater. Sci., 22 (2022) 64 – 77. https://doi.org/10.2478/adms-2022-0008 Lu, X. Guo, Y. Liu, X. Gong, Effects of particle size on flow mode and flow characteristics of pulverized coal, Kona Powder Part J., 32 (2015) 143 – 153. https://doi.org/10.14356/kona.2015002 ASTM C618, Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for use in concrete, ASTM International, West Conshohocken, PA, 2022. https://doi.org/10.1520/C0618-22 ASTM C150/C150M, Standard Specification for Portland Cement, ASTM International, West Conshohocken, PA, 2022. https://doi.org/10.1520/C0150_C0150M-22

Highlights

Selected types of waste papers were incinerated under the same conditions. The ashes derived from the incineration of waste papers were quantified. The flowability of the derived ashes was characterized. Although non-pozzolanic, the ashes showed chemical similarities with cement.

DOI

10.30684/etj.2024.146884.1695

First Page

430

Last Page

436

Download

Share

COinS