•  
  •  
 

Keywords

flow intensity, Bridge Piers, Morphology, Experimental investigation, 180-degree bend

Document Type

Research Paper

Abstract

Bridges when it crossing rivers often required multiple piers for support. One of has a limited investigation is the impact of piers on scouring and morphological aspects when a bridge crossing sharp-bend of river. Consequently, it is crucial to investigate the hydraulic behavior of water flow in these areas due to the presence of these piers. In present study, an experimental program was conducted on a laboratory flume featuring a two-pier bridge within a 180-degree (sharp) bend to accomplish this. The piers were strategically positioned at 90 and 150 degrees within the bend. The results indicated that the bridge within the 90o, under the threshold intensity condition, led to significant local scour depths around the piers. Specifically, the scour depths were found to be 1.80 and 1.15 times the width of the pier for the piers close to the outer and inner banks, respectively. The discharge increased from 240 l/min to 280 l/min while maintaining the same intensity of 0.85, resulting in a symmetric local scour depth at the pier near the outer bank. In contrast, the local scour depths in response to the piers in the 150o were considerably lower; at the threshold with a discharge of 280 l/min, the scour depths were measured to be 0.65 and 1.18 times the pier width for the inner and outer piers, respectively. Similar bed morphology was observed when the bridge was positioned at 150o for two discharge values (280 and 240 l/min) with the same intensity of 0.85. The findings showed that an increase or decrease in discharge value, with a constant intensity, did not influence the local scour depth and its extension around the pier close to the outer bank, indicating that the intensity component was more significant than the discharge.

References

Heidarnejad, M. S. Bajestan and  A. Masjedi,   The Effect of Slots on Scouring Around Piers in Different Positions of 180-Degrees Bends, World Appl. Sci., 8 (2010)  892–899. Oveici, O. Tayari, and N. Jalalkamali, Experimental (ADV & PIV) and Numerical (CFD) Comparisons of 3D Flow Pattern around Intact and Damaged Bridge Piers, Pertanika J. Sci. Technol., 28 (2020) 523–544. Solati, M. Vaghefi, and A. M. Behroozi, Effect of Duration and Pattern of Hydrographs on Scour Around Pier in Sharp Bend Under Incipient Motion and Live Bed Conditions, Int. J. Civ. Eng., 19 (2020) 51–65. https://doi.org/10.1007/s40999-020-00558-9 Moghaddassi, S. H. Musavi-Jahromi, M. Vaghefi, and A. Khosrojerdi, Effect of mean velocity-to-critical velocity ratios on bed topography and incipient motion in a meandering channel: Experimental investigation, Water, 13 (2021) 883. https://doi.org/10.3390/w13070883 Laursen E M and Toch A, Scour around bridge piers and abutments , 4, 1956. W. Shen, V. R. Schneider, and S. Karaki, Local scour around bridge piers, J. Hydraul. Div., 95 (1969) 1919–1940. W. Melville and A. J. Sutherland, design method for local scour at bridge piers, J. Hydraul. Eng., 114 (1988) 1210–1226. W. Melville, Pier and abutment scour: integrated approach, J. Hydraul. Eng., 123 (1997) 125–136. https://doi.org/10.1061/(ASCE)0733-9429(1997)123:2(125) Oliveto and W. H. Hager, Temporal Evolution of Clear-Water Pier and Abutment Scour, J. Hydraul. Eng., 128 (2002) 811–820. https://doi.org/10.1061/(ASCE)0733-9429(2002)128:9(811) Ettmer, F. Orth, and O. Link, Live-Bed Scour at Bridge Piers in a Lightweight Polystyrene Bed, J. Hydraul. Eng., 141 (2015) 1–10. http://dx.doi.org/10.1061/(ASCE)HY.1943-7900.0001025 Eghbalnik, M. Vaghefi, and M. R. GolbaharHaghighi, Laboratory study of the temporal evolution of channel bed topography in presence of two rows of inclined-vertical piers in a sharp 180-degree bend, ISH J. Hydraul. Eng., 28 (2019) 49–56. http://dx.doi.org/10.1080/09715010.2019.1674700 Asadollahi, M. Vaghefi, and M. J. Tabibnejad Motlagh, Experimental and numerical comparison of flow and scour patterns around a single and triple bridge piers located at a 180-degree sharp bend, Sci. Iran., 28 (2021)1-14. http://dx.doi.org/10.24200/sci.2019.5637.1391 Sedighi, M. Vaghefi, and G. Ahmadi, The Effect of Inclined Pair Piers on Bed Topography: Clear Water, Incipient Motion and Live Bed, Iran. J. Sci. Technol. - Trans. Civ. Eng., 45 (2021) 1871–1890. http://dx.doi.org/10.1007/s40996-020-00481-y A. Chooplou and M. Vaghefi, Experimental study of the effect of displacement of vanes submerged at channel width on distribution of velocity and shear stress in a 180 degree bend, J. Appl. Fluid Mech., 12 (2019). http://dx.doi.org/10.29252/JAFM.12.05.29329 Vaghefi, M. J. T. N. Motlagh, S. S. Hashemi, and S. Moradi, Experimental study of bed topography variations due to placement of a triad series of vertical piers at different positions in a 180° bend, Arab. J. Geosci., 11 (2018). http://dx.doi.org/10.1007/s12517-018-3443-4 Vaghefi, M. Moghanloo, D. Dehghan, and A. Keshavarz, Experimental Study of the Effect of Base-level fall at the Beginning of the Bend on Reduction of Scour around a Rectangular Bridge Pier Located in the 180 Degree Sharp Bend, J. Hydraul. Struct. Shahid Chamran Univ. Ahvaz J. Hydraul. Struct., 3 (2017) 32–46. http://dx.doi.org/10.22055/jhs.2018.24900.1065 Ben Mohammad Khajeh, M. Vaghefi, and A. Mahmoudi, The scour pattern around an inclined cylindrical pier in a sharp 180-degree bend: an experimental study, Int. J. River Basin Manag., 15 (2017) 207–218. http://dx.doi.org/10.1080/15715124.2016.1274322 Maatooq, and E. S. Mahmoud, Local Scour around Single Central Oblong Bridge Piers Located within 180° Bend, Int. J. Hydraul. Eng., 6 (2017)16–23. http://dx.doi.org/10.5923/j.ijhe.20170601.03 Emami, S. A. Salamatian, and M. Ghodsian, Scour at Cylindrical Bridge Pier in a 180 Degree Channel Bend, 2008. https://hdl.handle.net/20.500.11970/100126 Masjedi, B. Zeraat, and M. Hydarnejad, Experimental study on effect of ogival bridge pier on scour hole depth, in AIP Conf. Proc., 1376 (2011) 427–429. http://dx.doi.org/10.1063/1.3651937 Rasaei, S. Nazari, and S. Eslamian, Experimental and numerical investigation the effect of pier position on local scouring around bridge pier at a 90° convergent bend, J. Hydraul. Struct., 6 (2020) 55–76. http://dx.doi.org/10.22055/JHS.2020.32753.1134 A. Leschziner and W. Rodi, Calculation of strongly curved open channel flow, J. Hydraul. Div., 105 (1979) 1297–1314, 1979. Moghaddassi, S. H. Musavi-Jahromi, M. Vaghefi, and A. Khosrojerdi, Effect of mean velocity-to-critical velocity ratios on bed topography and incipient motion in a meandering channel: Experimental investigation, Water, 13 (2021) 1–22. http://dx.doi.org/10.3390/w13070883 Solati, M. Vaghefi, and A. M. Behroozi, Effect of Duration and Pattern of Hydrographs on Scour Around Pier in Sharp Bend Under Incipient Motion and Live Bed Conditions, Int. J. Civ. Eng., 19 (2020) 51–65. http://dx.doi.org/10.1007/s40999-020-00558-9 M. Chiew and B. . Melville, Local scour around bridge piers, J. Hydraul. Res., 25 (1987) 15–26. http://dx.doi.org/10.1080/00221688709499285 Wang, H. W. Tang, J. F. Xiao, Y. Wang, and S. Jiang, Clear-water local scouring around three piers in a tandem arrangement, Sci. China Technol. Sci., 59 (2016) 888–896. http://dx.doi.org/10.1007/s11431-015-5905-1 Heidarnejad, M. S. Bajestan, and A. Masjedi, The Effect of Slots on Scouring Around Piers in Different Positions of 180-Degrees Bends, World Appl. Sci. J., 8 (2010) 892–899. J. Raudkivi and R. Ettema, Clear-Water Scour at Cylindrical Piers, J. Hydraul. Eng., 109 (1983) 338–350. S. Maatooq and L. Hameed, Identifying the pool-point bar location based on experimental investigation, J. Water Land Dev., 43 (2019) 106–112. http://dx.doi.org/10.2478/jwld-2019-0068 Akbari and M. Vaghefi, Experimental investigation on streamlines in a 180o sharp bend, Acta Sci. - Technol., 39 (2017) 425–432. http://dx.doi.org/10.4025/actascitechnol.v39i4.29032 Vaghefi, M. Akbari, and A. R. Fiouz, An experimental study of mean and turbulent flow in a 180 degree sharp open channel bend: Secondary flow and bed shear stress, KSCE J. Civ. Eng., 20 (2015) 1–12. http://dx.doi.org/10.1007/s12205-015-1560-0

Highlights

Maximum scour depth, is 1.8 times the pier width for the bridge at 90o and much lower at the pier at 150o The change of discharge value with the same intensity creates symmetric morphology vicinity of the piers The findings showed that the intensity component was more significant than the discharge

DOI

10.30684/etj.2023.140134.1455

First Page

1241

Last Page

1251

Download

Share

COinS